NEW AND IMPROVED XT-60 BATTERY CAP!

I was tired of losing my XT-60 caps every time I go flying drones. Especially when I was buying them and did not have a 3d printer to replenish my supply.

So I redesigned the extremely basic cap you see available everywhere on the internet today into a something that just works better, not to mention looks way cooler.

This new xt-60 connector cap design features a finger grab section on top for ease of installation and removal, and the never seen before retention loop on the side of the cap. Use this loop to store your battery's cap on an open switch of your transmitter while you fly. As soon as you're done RIPPING that pack, easily find and reinstall your protective cap which is hanging conveniently where you last stuck it! Heck, you could even keep some back ups on your gear bags key rings. Imagine the possibilities!

Head over to Thiniverse now and download the .stl! Click Here.

Please visit my site where I sell pre-printed versions as well for those of you not so lucky in the printer department. Enjoy

-Alex, SAVFPV